Schedule Set With You
Job days are planned around tenants, services, shipping, or harvest, and shared with the building contact.
About Our Noblesville Metal Roof Coating Work
How We Inspect, Repair, and Coat Commercial Roofs
About our Noblesville metal roof coating work: we walk the roof first, put the repairs in writing, and coat only roofs that will hold the coating.
- Written scope before work starts
- Moisture readings on every roof walk
- Thickness records at the end
What to Know About Our Noblesville Metal Roof Coating Work
About our Noblesville metal roof coating work in short: the roof decides the job. We coat steel, low-slope, foam, and shingle roofs for commercial owners, and every job starts with a roof walk.
Repairs come before coating on every roof. A coat over loose screws or wet insulation hides problems for a season, so we fix those first and put the plan in writing.
- Photos and a written repair list after each walk
- Repairs done before any coating
- Thickness readings logged by section
What Every Roof Walk Covers
A roof walk takes an hour or two on most buildings. These are the parts we check every time.
Fasteners and Washers
Loose, stripped, and rusted screws are marked row by row, with cracked washers counted for the repair list.
Laps and Seams
Side laps, end laps, and single-ply seams get checked for open sealant, lifting edges, and rust.
Curbs and Penetrations
Rooftop unit curbs, skylights, vents, and pipe boots are inspected, since leaks often start at those spots.
Moisture Below the Surface
Readings near stains and low areas show whether insulation under the roof is wet.
Drainage at the Edges
Gutters, downspouts, scuppers, and drains are checked for blockage, rust, and open seams.
Want a Written Scope Before Deciding?
A roof walk ends with photos and a repair list you can keep, whether or not the roof gets coated.
How a Job Runs After the Walk
Once the scope is signed, the work follows a set order on every building.
Repairs Before Coating
Screws, laps, curbs, panels, and wet insulation are handled first, so the coating goes over a tight roof.
Coating to Thickness
Each pass is checked with a wet film gauge and topped up wherever a reading comes up short.
Handover at the End
You get photos, thickness readings by section, and a short upkeep list for spring and fall checks.
Jobs We Take On and Jobs We Pass On
Coating fits many roofs, but some need other work first or instead. These cards show where the line falls.
Jobs We Take On
- Roof
- Commercial steel, low-slope, foam, or shingle
- Panels
- Attached and mostly intact
- Insulation
- Dry, or wet spots replaced
- Leaks
- At details we can repair
- Our Answer
- Repair, then coat
Jobs We Pass On
- Roof
- Residential homes
- Panels
- Rusted through across the field
- Insulation
- Soaked throughout
- Leaks
- Structural, from framing damage
- Our Answer
- Refer to replacement or structural work
Questions About Our Noblesville Metal Roof Coating Work
Do you coat home roofs?
Our work is commercial only: shops, warehouses, plants, offices, churches, retail buildings, and farm buildings.
What happens if the roof walk shows the roof is past coating?
You get the same photos and repair list, along with our reasons. Replacement is the right call on some roofs, and we say so plainly.
Who do I talk to during the job?
Call (463) 288-8746. The building contact also gets a daily plan showing which roof section is being worked.
What records do I get at the end?
Photos before and after, thickness readings by roof section, and a short list of upkeep checks for the coming seasons.
Talk About Our Noblesville Metal Roof Coating Work
Call with questions about your roof, or send the address through the ballpark form to start.